1 of 3 pages
VIS0481 LED Multipar 18 x 5 in 1 RGBAW Operation Manual
The
5IN1 LED Multipar
provides an extremely powerful light source. Controlled via digital display
through the three buttons------MODE, UP, DOWN. It can function store when it is turned off, resuming this
program when turned back on. This product has a temperature protection function, turning off automatically if
the temperature exceeds 85°C.
A Specification:
1. Weight: 6.2kg
2. Size: 330 x 270 x220mm
3: Supply: AC 120V/240V, 60HZ/50HZ
4: Consumption: 165W max
5: LEDS: 18 x 10W (RGBWA 5 in 1)
6: Beam angle: 40°
7: 3PIN female XLR socket and 3PIN male XLR socket
8: Built-in microphone
9: LED digital display
10: IR remote available (VIS0499 available separately)
Operation modes are accessed via Mode button as follows (To make the display stay on constantly press the
MODE and UP buttons at the same time. To make the display turn off after 20 seconds, press the MODE and
DOWN buttons at the same time.)
1. Static colour select mode
Press“MODE ” button to select static colour program mode. The digital display reads “C.X X”. Press “UP” or
“DOWN” to select individual colours.
2. Colour snap mode
Press“MODE” button,to select colour snap change mode. The digital display reads “J.X X”. Press UP or
DOWN to select the change speed 1-99 (from slow to quick)
3. Colour fade mode
Press“MODE” button,select colour fade mode. The digital display reads “F.XX”. Press UP or DOWN to select
fade speed 1-99 (from slow to quick).
4. Auto-run mode
Press“MODE”button,to select auto mode. The digital display reads “A.- -” The colour snap change program and
colour fade program run alternatively. The UP or DOWN buttons have no effect in this mode - running speed is
determined by the current speed of colour snap and colour fade programs.
5. Sound-active mode
Press“MODE” button to select sound-active mode. The digital display reads “S.XX”. Press UP or DOWN to
select sound sensitivity from 0-31. 0 is off, 1 is the lowest sensitivity, 31 is the highest.
6. Slave mode
Press“MODE” button to select Slave mode. The digital display reads “S.L.A.”. The UP or DOWN buttons have
no effect in this mode.
7. DMX mode
Press MODE button to select DMX mode. The digital display shows DMX address“X X X”. Press UP or DOWN
to select DMX address.You can set 512pcs address. It will flicker when there is no controller signal.
