Chapter 3 Control Box 11
2.
Disconnect cables from front of control box.
3. Remove two Phillips screws as shown below from front panel of control
box:
4
Remove the front panel and bezel from the control box.
5
Slide the top cover forward and clear of the control box.
6. Reconnect the HMD connector to the control box output.
To reassemble, reverse the above procedure. Be careful to slide the cover into
the correct channels on the control box base. Use normal caution in working
with the exposed board regarding ESD (electrostatic discharge). The compo-
nents are not highly susceptible to ESD, but can be damaged if normal precau-
tions are not followed.
