VIRATA ATMOS Console, Справочник по командам

Страница: 46 / 248

device add
36 ATMOS Console Commands Reference Manual (Binary) DO-008530-PS, Draft B (26th April 2001)
4.1 device add
4.1.1 Syntax
device add <device>
4.1.2 Description
This command adds a device to the bridge configuration. Attempts to
add the bridge itself or an existing device to the bridge are rejected.
Attempts to add devices which don’t support the Cyan interface are
rejected. There is a limit on the number of devices that can be attached
to the bridge. If the device being added is from a process which supports
multiple devices, the
/DEVICE attribute must be specified as part of the
device name. The table below shows devices which may be attached to
the bridge, although not all systems may support all devices.
Configuration saving saves this information.
4.1.3 Example
Simple examples
device add edd
device add ppp/DEVICE=2
Using the BUN RFC1483 driver
This example shows how to add the BUN RFC1483 driver, dynamically
from the console. You need to define and configure a device and a port.
Normally, the RFC1483 BUN device will pass all data straight through,
untouched. This means that even though you have changed your port
definition to include the RFC1483 driver, you can still use other
protocols on the same port. In order to enable RFC1483 encapsulation,
the RFC1483 attribute on the channel must be set to
true .
Device Remarks
edd Ethernet driver
bun RFC1493 protocol (PVC)
ppp Point-to-Point protocol