Printer Maintenance
47
Replacing the Output Module/Cutter Assembly
Keep the cutting zone free from debris. Check cut labels to ensure that the cuts have
clean edges and replace the cutter assembly when necessary.
Removal
1. Press the Power button on the control panel to turn off the printer. Also turn off
the Power switch at the back of the printer.
2.
to its highest position.
3. Locate the wire harness connector (labeled P107) for the output module
(
). Use a small flat-head screwdriver to release the connector and
separate it.
4. Carefully cut the cable ties securing the cables to the left side of the clamshell.
Be careful not to cut any of the cables.
Tools
• Nitrile powder-free gloves
• Small flat-heat screwdriver
• T10 Torx driver
• Scissors or cutter (for cable ties)
• Cable ties
NOTE:
Before you begin, remove the printhead and cap it with the orange
protective cover.
a
b
Содержание VP6 Series
Страница 1: ...U s e r G u i d e VIPColor VP6xx Printer Series ...
Страница 36: ...36 Using the Printer ...
Страница 58: ...58 Printer Maintenance ...