VIPA TM-E 900-1E650, Руководство пользователя

Страница: 30 / 78

Chapter 4 Deployment TM-E
Manual VIPA TM-E
3-2 HB39E - TME - RE_900-1E650 - Rev. 09/11
Fast introduction
The information in this manual should simplify you the deployment of
remote controlling VIPA PLCs. More information concerning this may be
found in German and English at:
suppport.ewon.biz
www.ewon-online.de
The module TM-E from VIPA is constructed in the same way as the module
"eWON2001".
The TM-E module is to be supplied with DC 12...24V
±
20%. The
connection is established by a plug. This may be found at the lower side of
the module and has the following allocation:
Pin Name Meaning
1 GND Ground power supply
1
2 2 12-24V DC DC 12 ... 24V
±
20%
For the access to the TM-E-Modul valid IP address parameters are
necessary. The IP addresses are assigned by the network administrator
and must be coordinated with him.
The TM-E module is delivered with the following IP address parameters:
IP address: 10.0.0.53
Subnet mask: 255.255.255.0
To change the IP address parameters the configuration tool "eBuddy" from
VIPA may be used.
Caution!
For every TM-E module is delivered with the IP address 10.0.0.53 you must
not connect more than one new TM-E module at one time.
First commissioning: Connect the new TM-E module with the network,
assign TCP/IP address parameters. Now you may connect the next new
TM-E module and so on ...
Connect your PC to your TM-E module via Ethernet. Here either a crossed
cable or a switch may be used.
An active link via Ethernet is shown by the TM-E module with the green
"LINK" led.
Important note!
Power supply
IP address
parameters on
delivery
Linking to
Ethernet