VIO 7 Vio, Инструкция по эксплуатации

Страница: 33 / 34

33
Rev. 1 20.12.2019
EN
P9.6 Select Parameters
Function available only for PC 7 Vio
Through this setup menu it is possible to select which parameters do NOT display in measurement mode.
Access menu P9.6. The icon
flashes, with directional keys select:

YES: in measurement mode the pH parameter is displayed

NO: in measurement mode the pH parameter is not displayed
Confirm the selection with , now the icon flashes, then repeat the same operation for the mV
parameter and then for all the parameters up to the TDS .
Example: The user wishes to work only with the pH, Conductivity and TDS parameters.
In the P9.6 menu:
pH -> YES / mV -> NO / ORP -> NO / COND -> YES / TDS -> YES
Press twice to return to measurement mode. Scrolling with the key only the parameters pH,
COND and TDS are present.
Note:
At least one of all the parameters must be enabled with YES
P9.8 Reset Settings
Access this setup menu to restore the instrument to factory conditions.
P9.9 Auto-Off
Access this setup menu to activate or deactivate the auto-shutdown of the instrument:

YES:
The instrument automatically turns off after 20 minutes of inactivity

NO: The instrument remains always on even if you are not using it
IMPORTANT: The correct and systematic use of parameters P9.3 / P9.4 / P9.5 / P9.9 allows to significantly
extend battery life
Warranty
Warranty period and limitations

The manufacturer of equipment provide five years of warranty from the date of purchasing only
and exclusively on electronic parts of the device, only upon right maintenance and professional use.

During the warranty period, the manufacturer will repair or replace defective components, if
covered by warranty.

This warranty does not apply if the product has been damaged, used incorrectly, exposed to
radiation or corrosive substances, if foreign materials have penetrated inside the product or if
unauthorized modifications have been made by the customer without approval from the
manufacturer.