106
Replacing tripod legs (150 mmEFP tripods)
Introduction
1
The legs are secured in the bowl assembly by clamp plates. Each clamp plate is secured by a single
screw.
Consumables
2
The following adhesive will be required:
Loctite 221 (Vinten Part No. Z002-026)
Removal
3
Remove the tripod leg as follows:
3.1
Remove two screws
and leg pivot clamp plates
securing the tripod leg
3.2
Pull off the tripod leg
. Note orientation and remove two pivot washers
.
Installation
4
Install the tripod leg as follows:
4.1
Install two two leg pivot washers
on the tripod leg
, oriented as noted in removal
4.2
Position the leg in the bowl
4.3
Install the leg pivot clamp plates
and secure with screws
, using Loctite 221. Tighten
screws
so that the leg is self-supporting when set at 45°.
NOTE:
Do not apply any lubricant to the bowl, the leg trunnions, leg pivot friction rings or
washers.
Содержание Vision Pozi-Loc
Страница 1: ...Contents Vinten Camera Control Solutions Next Page Previous View Vision Pozi Loc Tripods ...
Страница 8: ...8 Contents Previous Page First Page Next Page Previous View Part 1 Illustrated Parts Lists ...
Страница 85: ...85 Contents Previous Page First Page Next Page Previous View Part 2 Repairs ...
Страница 107: ...107 Contents Previous Page First Page Next Page Previous View Replacing tripod legs EFP tripods 1 2 3 4 5 2 3 4 ...