51
36.3 Connect the battery and position in forward LH compartment. Install LH cover plate (14) and
secure with three screws (6).
36.4 Press bubble illumination switch and ensure LED is lit for approximately 15 seconds.
36.5 Install RH cover plate (7) and secure with three screws (6).
36.6 If removed, adhere buffer pad (3) to brake lever cover plate (4) using Loctite 406.
36.7 Install brake guide housing (5) and brake lever cover plate (4) and secure with four screws (6).
Spring-loaded flap
37
To assemble the spring-loaded flap, proceed as follows
:
37.1 At each side of the flap (6), install the appropriate flap spring (3, NI), ensuring that right-angle
bend in spring faces outwards and engages with slot in flap.
37.2 At each side of the flap, install a spring (5) and flap pin (2) and secure with Spirol pin (4). Ensure
assembly slides freely in flap.
38
To install the spring-loaded flap, proceed as follows
38.1 Hold the pins (4) inwards and position the flap, ensuring straight legs of flap springs (3, NI)
engage in holes in mechanism housing (1).
38.2 Operate the flap and ensure that springs return it to the closed position.
NOTE:
The flap springs (3, NI) are handed.
Содержание Vector 700
Страница 1: ...Contents Nafl f Camera Control Solutions Next Page Previous View Vector 700 700H Black ...
Страница 10: ...10 Contents Previous Page First Page Next Page Previous View Design Improvements DETAILS SERIAL No INFORMATION ...
Страница 54: ...54 Contents Previous Page First Page Next Page Previous View ...