48
30.4 Centralize pin (24) and install drag knob boss (25).
30.5 Install the balance knob (26) and secure with washer (27) and screw (28).
30.6 Install knob bung (29).
Tilt Drag
31
Install the tilt drag mechanism as follows
31.1 If removed, install bearing (26) on shaft of tilt drag assembly (25) and secure with snap ring (27).
If removed, install dowel (28) in face of tilt drag assembly (25) so that it protrudes by 2.5 mm
31.2 Install tilt drag shaft in mechanism housing, passing shaft through LH actuator (32), bearings (12)
and shim (13)
31.3 Secure tilt drag assembly (25) to mechanism housing (10) with two 12 mm screws (11) and three
16 mm screws (19), noting that 12 mm screws go to top of tilt drag assembly.
31.4 Ensure LH actuator (32) is central in mechanism housing and fully tighten screw (30),
31.5 Install the drag knob (44) and turn fully counter-clockwise. It may be necessary to remove and
reposition the drag knob to enable drag to be reduced to zero.
31.6 Turn the knob clockwise half a drag scale division.
31.7 Remove the knob and refit so that ‘0’ on knob is adjacent to mark on tilt drag housing and stop on
knob abuts adjuster. If necessary, adjust stop as follows
31.7.1
Remove knob (44).
31.7.2
Slacken screw (25.3) securing stop (25.2) to the tilt drag mechanism (25).
31.7.3
Refit knob (44) so that ‘0’ on knob is adjacent to mark (24.1) on tilt drag housing.
31.7.4
Move stop until it abuts stop (44.1) on knob. Remove the knob and tighten screw
(25.3).
31.7.5
Refit knob (44) and turn clockwise to maximum drag and ensure scale reading exceeds
‘9’. Turn knob fully counter-clockwise and ensure scale reads ‘0’ when stop is reached. Re-adjust
knob and/or stop as necessary.
31.8 Turn knob fully counter-clockwise and remove.
31.9 Lightly lubricate two springs (49) and two steel balls (48) with LM grease and install in the tilt drag
mechanism (23).
31.10 Install drag detent ring (43) in knob (44) and install on tilt drag mechanism with ‘0’ on knob
adjacent to mark on base casting. Secure with washer (45) and screw (46) and fit knob bung (47).
Содержание Vector 700
Страница 1: ...Contents Nafl f Camera Control Solutions Next Page Previous View Vector 700 700H Black ...
Страница 10: ...10 Contents Previous Page First Page Next Page Previous View Design Improvements DETAILS SERIAL No INFORMATION ...
Страница 54: ...54 Contents Previous Page First Page Next Page Previous View ...