17
11
When the payload C of G height adjustment is complete, check that the fore and aft balance remains
satisfactory. Re-adjust the position of the sliding plate if necessary.
12
After balancing, release the brakes
and exercise the head through both axes to confirm that it
operates smoothly.
Operation
Locking the platform
13
The centre lock mechanism is operated by a plunger
on the right-hand side of the head. The lock is
engaged by holding the platform level and pushing the plunger inwards until the release lever
appears.
Use the pan bar to rock the platform slightly whilst pushing the button. To release the centre lock, rock the
platform slightly and push down on the release lever
Pan and tilt brakes
14
The pan and tilt brakes are operated by levers
at the rear of the head. They are applied by pulling
the appropriate lever up and back and released by pushing the lever forwards. The brakes should be applied
whenever the camera is left unattended.
Pan and tilt drag
15
The pan drag adjustment knob
is mounted on the left-hand lower part of the main body. Tilt drag is
adjusted by a knob
mounted on the face of the tilt drag housing on the left-hand side of the head. Turn the
knobs clockwise to increase drag and counter-clockwise to decrease drag.
WARNING!: Use only hand force to adjust drag. Do not over-tighten.
Содержание Vector 700
Страница 1: ...Contents Nafl f Camera Control Solutions Next Page Previous View Vector 700 700H Black ...
Страница 10: ...10 Contents Previous Page First Page Next Page Previous View Design Improvements DETAILS SERIAL No INFORMATION ...
Страница 54: ...54 Contents Previous Page First Page Next Page Previous View ...