Vino Rails for Wood Surfaces
Installation instructions for Vino Rails (SKUs: VR-)
Included Parts
• (2) Vino Rails
• (2) Wood Lags
• (1) Hex Key
• (2) Nuts
• (1) 8.5”x11” Plotting Guide
Required Tools
• (1) Level
• (1) Drill
• (1) 5/32” (4mm) Drill Bit
• (2) 10mm or adjustable
wrenches, or...
• (1) M6 Driver (recommended)
Important Note:
The following instructions are for installing Vino Rails for Wood Surfaces (standard wine
bottles, 750ml). Installation surfaces must have a minimum thickness of 1/2” (13.7mm). Please reference the
BILT 3D app and/or product specific guides for drywall-backed or Magnum bottle (1.5L) instructions.
Figure B
1. MARK MOUNTING HOLE LOCATIONS
Use a level to ensure the printed mounting template is
horizontal along the long edge (Figure A), mark hole
locations by piercing the template with a pencil or sharp
at the center the two (2) marks corresponding with the
bottle direction chosen. Mounting holes will be 2-1/2”
(65mm) apart.
For Magnum racking, adjust to 3” (77mm) but reference
product specific instructions.
Pro Tip: To plot additional Vino Rails in the same column,
mark a minimum of 5” (127mm) above or below each
mounting hole for next set of Vino Rails.
2. CONFIRM WALL SURFACE
Drill two (2) pilot holes using a 5/32” (4mm) Drill Bit
(Figure B) to determine whether your installation will
be into solid wood or drywall surface.
NOTE: If it is determined to be drywall, please use
(or purchase if necessary) Vino Series Collars and
reference the Vino Rails with Collars (SKUs: VRC-)
install guide.
Figure A
