VAC6P
In-Ceiling/In-Wall Installation Instructions
If you are not familiar with a 70V/100V Distributed Audio System, we would highly recommend that you
contact a trained professional to do the installation.
Safety Instructions:
-
Read all instructions
-
Keep these instructions
-
Be aware of all warnings and safety precautions
-
Do not use this product in or near water or other liquids
-
Do not use any aerosol cleaner or disinfectant on this product
-
Ensure that the installation hole size is cut accurately
-
When cutting your installation hole, ensure that you are free and clear of all electrical wire and
plumbing pipes
-
When daisy-chaining speakers, ensure that the sum of the tapped wattage of all speakers in the
chain do not exceed 80% of the maximum output wattage of the connected amplifier channel
-
Verify that your installation complies with all local codes
Specifications:
VAC6P
Specifications
Transducer:
6.5" Polypropylene Cone w/ Rubber Surround
0.5" Pivoting PEI Dome Tweeter
Power Rating:
6W RMS
Transformer Taps:
70V: .75W, 1.5W, 3W, 6W
100V: 1.5W, 3W, 6W N/C
Impedance:
8
Ω
Frequency Range:
50Hz - 20 kHz
Sensitivity:
88 dB @ 1w/1m
Coverage:
110
°
Conical
Su
rface Preparation
1.
Use the supplied template to mark your installation hole in the proper ceiling or wall location.
Carefully, cut out the installation hole.
2.
For unfinished ceilings and walls, a new constructions bracket (VAGIC6NCB
;
sold separately), is
needed to be installed prior to the drywall being installed. Attach the new construction bracket, ensuring
that the hole of the bracket is in the desired location.
Wiring Installation
1.
Run the wire (18-14-guage) from the amplifier location to the cutout. Allow for an extra foot of wire
at the cutout.
2.
To attach the speaker to your amplifier, connect the
output of the amplifier to the “Com” (black)
wire of the speaker tap. Connect the
of the amplifier to the colored cable of the speaker tap that
represents the desired speaker wattage.
