Exigo Ex Access Panels & Turbine Ex Intercoms
Mounting Manual
Product Overview
Mounting procedures are the same for all units in the Exigo and Turbine Ex series.
Contents of this Delivery
The unit comes with 4 blind plugs already mounted. The front frame is fastened with 2 socket-head cap M6 screws.
Important Notes before Mounting
Improper installation and operation of the Ex unit will result in the invalidation of the warranty.
The enclosure/housing must not be opened when the unit is powered.
The installation and connection of Ex units may only be carried out by qualified/approved personnel
General Mounting Considerations
When the Ex unit is mounted directly onto a wall or mounting plate, it shall rest only on the fastening points provided for
this purpose. The surface must be even and flat.
The unit must be mounted on a surface to prevent access from the rear of the unit.
Do not use countersunk screws.
Due to the cabinet material, use as low a tightening torque as possible when mounting the unit to the surface (1.5 Nm max.)
Washers are recommended.
Do not use more than 2.5 Nm torque when fastening the 12 screws into the front frame.
On Mounting Plate or Column - recommended screws:
M5 x 20 or 25 with Philips head DIN7985 or Torx. Head diameter: 10 mm.
On Wall - recommended screws:
Panhead – DIN7981 for plug or wooden wall, etc. Head diameter: 10.8 B5.5 x 38 or 45 mm.
EAPFX-6
1023221516
EAPFX-1
1023221511
1 Cable Gland
M25 Ex e
Exigo Ex Access Panels & Turbine Ex Intercoms
Mounting manual
Station overview
Installation procedures are the same for all panels in the Industrial Ex series.
Contents of this delivery
Note! The unit are equipped with four blind plugs, front frame is fastened with 2 unbraco M6 screws
Important notes before mounting
Improper installation and operation of the Ex access panel will result in the invalidation of the guarantee.
The enclosure/housing must not be opened when the product is powered.
The installation and connection of Ex units may only be carried out by qualifi ed / Approved personnel
Mounting, general
When the Ex Product is mounted directly onto a wall or mounting plate, it shall rest only on the fastening points provided for
this purpose. The surface must be even and fl at.
The unit must be mounted on a surface to prevent access from the back
Do not use countersunk screws.
Due to the cabinet material, use as low a tightening torque as possible
Washers are recommended
Do not use more than 2.5 Nm torque when fastening the 12 screws in the front frame.
On Mounting plate or column, recommended screws:
M5 x 20 or 25 with Philips head DIN7985 or Torx. Head diameter 10mm.
On Wall, recommended screws:
Panhead – DIN7981 for plug or wooden wall, etc. Head diameter 10.8 B5.5 x 38 or 45 mm
EAPFX-6
1023221516
EAPFX-1
1023221511
1x Cable Gland
M25 ATEX e
1x Cable Gland
M16 ATEX e
10 x Unbraco
screw M6
1x Ex Station
TFIX-1
1008123010
TFIX-2
1008123020
TFIX-3
1008123030
This manual
1 Cable Gland
M16 Ex e
10 socket-head
cap M6 screws
(+ 2 fastened to
front frame)
1 Ex Unit
TFIX-1
1008123010
TFIX-2
1008123020
TFIX-3
1008123030
This Manual
TFIX-4
1008123040
