9. Programming and deleting the remote control.
The maximum storage capacity is 128 remote controls.
Caution: The remote controls can only be saved and deleted when the gate is stationary.
Programming the button of the remote control associated with input SEQ.
1. Press push button P2 and hold it down until LED DL7 (PRG) starts to flash (1
st
flashing frequency).
2. Release push button P2.
3. Within 10 seconds, activate the radio control button to be learnt and associated with the sequential or start control.
4. Learning procedure completion will be signalled by the flashing of the flashing lamp, followed by the LED DL7 that stops flashing.
5. Repeat the process for every radio control to be learnt.
Programming the button of the remote control associated with input PED.
1. Press push button P2 and hold it down. LED DL7 starts to flash (1
st
flashing frequency).
2. Do not release push button P2 until it flashes faster (2
nd
flashing frequency).
3. Release push button P2.
4. Within 10 seconds, activate the radio control button to be learnt and associated with the pedestrian control.
5. Learning procedure completion will be signalled by the flashing of the flashing lamp, followed by the LED DL7 that stops flashing.
6. Repeat the process for every radio control to be learnt.
Programming the button of the remote control associated with P.OUT for the 2
nd
radio channel (Dip switch 10 must be OFF).
1. Press push button P2 and hold it down. LED DL7 starts to flash (1
st
flashing frequency).
2. Do not release push button P2. The flashing becomes faster (2
nd
flashing sequence).
3. Do not release push button P2 until it flashes faster (3
nd
flashing frequency).
4. Release push button P2.
5. Within 10 seconds, activate the radio control button to be learnt and associated with the +P.OUT control.
6. Learning procedure completion will be signalled by the flashing of the flashing lamp, followed by the LED DL7 that stops flashing.
7. Repeat the process for every radio control to be learnt.
Deleting a single remote control saved.
1. Press push button P2 and hold it down. LED DL7 starts to flash (1
st
flashing frequency).
2. Do not release push button P2. The flashing becomes faster (2
nd
flashing sequence).
3. Do not release push button P2. The flashing becomes faster (3
nd
flashing sequence).
4. Do not release push button P2 until it flashes faster (4
nd
flashing frequency).
5. Release push button P2.
6. Within 10 seconds, activate the button of the remote control to be deleted.
7. Learning procedure completion will be signalled by one flash of the flashing lamp, followed by the LED DL7 that stops flashing.
Deleting all the saved remote controls
.
1. Disconnect the power supply to the control unit.
2. Reconnect the power supply to the control unit by holding down push button P2.
3. Wait for the DL7 LED to stop flashing.
4. At the end of this procedure, all the remote controls in memory are deleted.
29
SW230.T / SW230.T.120
EN
