23
9.3.9 General parameters - Switch-off delay (hh:mm:ss)
Options:
0.00.10 .. 0.05.00 .. 18.12.15
- The switch-off delay is the time period between the last movement detected and the sending of the telegram "Value for switch-off". If movement is detected
again within this period, the switch-off delay timer is started again.
9.3.10 General parameters - Brightness-value threshold internal (lux)
Options:
1 ... 400 ... 1000
- The brightness-value threshold is used to specify the lux value at which the detector is to start to respond. If the detector does not switch on and the meas-
ured brightness lies above the set threshold, no telegram is sent during movement.
9.3.11 General parameters - Sensitivity of the watchdog
Options:
High
Medium
Low
-
High
: Standard - intended for indoor use.
-
Medium
: To be used when there are small interfering heat sources within the detection area.
-
Low
: To be used when there are large interfering heat sources within the detection area.
Note
The transmission range can NOT be changed via the sensitivity.
9.3.12 General parameters - Fade in extended parameters
Options:
No
Yes
-
No
: Only the most important parameters for setting the detector are displayed
-
Yes
: All parameters are displayed, also those that are not required in most cases. Examples:
› Extended parameter settings
› Status display parameter
› Brightness parameter
› External button parameter
9.3.13 Extended parameter settings - Operating mode
Options:
Automatic mode
Automatic switch-off
Automatic switch-on
Monitoring
-
Automatic
: automatic switch-on and switch-off
-
Automatic switch-off
: manual switch-on and automatic switch-off
-
Automatic switch-on
: automatic switch-on and manual switch-off
-
Monitoring
: automatic switch-on when there is sufficient movement within a specific time period and automatic switch-off after a fixed switch-off delay of
2 seconds
›
Automatic
: In "Automatic" mode the detector switches on automatically when detecting a movement. The switch-off is effected after the set switch-off
delay beginning from the most recent detection.
›
Automatic switch-off
: In "Automatic switch-off" mode the detector must be switched on manually via object "External push-button (input)". The switch-off
is effected automatically under consideration of the switch-off delay.
›
Automatic switch-on
: In "Automatic switch-on" mode the detector switches on automatically when detecting a movement. The switch-off is effected by the
receipt of an Off telegram on object "External push-button (input)". Note: The detector switches off automatically after 6 hours.
›
Monitoring
: In "Monitoring" mode the detector switches on brightness-dependent if an adjustable component of movement has been recorded within the
time period set. The switch-off occurs 2 seconds after switch-on and the last detection of movement.
Note:
Manual switch-on and switch-off is possible in operating modes automatic, automatic switch-on and automatic switch-off via the external push-button (input).
This external push-button is activated under the "External push-button" parameter. During manual switch-off the detection of movement is suppressed for
the pause time. The purpose of pause time is to prevent an immediate reactivation.
Example: The person switches the light off manually when leaving the room. Without the pause time the detected movement would cause a renewed switch-
on during exiting.
Description of application and parameters
"Detector" application
