Villagepump 500 Standard, Руководство по эксплуатации и обслуживанию

Страница: 9 / 30

O&M Manual v.1.42 October 2017
9
If the distance (static head) between Villagepump and water level is higher than 3 meters, we
recommend to put the Fork on the second or third hole. The Feed Pump will create a higher
vacuum and more water can be primed from a higher level.
4.2 Connecting Inlet Hose and Drain Hose
Mounting hoses for inlet (A) and drain (B)
Connecting the Inlet Hose (A)
The Inlet Hose is directly connected to the Feed Pump, through a hole in the frame.
- Put the Inlet Hose through the hole and put the Hose Clamp on the hose.
- Push the Inlet Hose from outside over the nipple as far as possible.
- Shift the Hose Clamp at the right spot and connect the Hose Clamp firmly!
Note: be aware that this connection should be completely air-tight because the Feed
Pump operates with a vacuum.
Note: keeping the Inlet Hose out of full sunlight will extend the life time. We
recommend to bury the Inlet Hose in the ground or cover the hose with sand of other
materials