7
A. Initiating a Page
B. Selecting Zones
Operation
1. Ring Trip Paging
1. Selecting Zones with One ZPI-4
2. Selecting Zones with Multiple ZPI-4’s
To access the
ZPI-4
for ring trip paging, call the PABX/KSU station number the
ZPI-4
is connected to. The
ZPI-4
will answer on the first ring, produce dial tone (if enabled) and await Touch Tone entry for 10 seconds.
If there is a Touch Tone entry, the
ZPI-4
activates the selected zone(s). If there is no Touch Tone entry in 10
seconds, the
ZPI-4
disconnects.
3. Paging from a Phone System’s 600 Ohm Paging Port
To page in this situation, access the phone system’s paging port. The
ZPI-4
will detect that a page is being initiated and wait for a Touch
Tone entry. When it sees an entry, it activates the selected zone(s).
To make a page with the
ZPI-4
installed on a spare trunk port, simply
access the trunk connected to the
ZPI-4
. The
ZPI-4
will produce dial
tone (if enabled), wait for Touch Tone entry, and activate the selected
zone(s) when it sees a Touch Tone entry.
2. Paging from an Unused Phone System Trunk Input
Enter a single Touch Tone to select the zone or zones to be paged.
After this entry has been made, the
ZPI-4
activates the selected
zone(s). See table to the right.
Touch Tone
Zone(s)
1
1
2
2
3
3
4
4
5
1+2
6
2+3
7
3+4
8
1+2+3
9
2+3+4
0
1+2+3+4 (ALL)
Touch Tone
Primary Unit
Zone(s)
11
1
1
12
1
2
13
1
3
14
1
4
15
1
1+2
16
1
2+3
17
1
3+4
18
1
1+2+3
19
1
2+3+4
10
1
1+2+3+4 (ALL)
Touch Tone
Unit
Zone(s)
0
ALL
ALL
Touch Tone
Secondary
Unit
Zone(s)
21
2
1
22
2
2
23
2
3
24
2
4
25
2
1+2
26
2
2+3
27
2
3+4
28
2
1+2+3
29
2
2+3+4
20
2
1+2+3+4 (ALL)
D. Dip S witch Programming
12
3
on
4
5
OFF ON
DIP Switches
Note:
DIP switches should be set prior to powering up the
ZPI-4
. If power has already been applied, momentarily
power down the unit so the switches will take effect.
* Factory defaults
Switch
Position
Description
1
ON
Single amplifier
1
OFF
Two or more amplifiers *
2
ON
Two units
2
OFF
Single unit *
3
ON
Secondary unit
3
OFF
Primary unit *
4
ON
Dial tone enabled
4
OFF
Dial tone disabled *
5
ON
Page alert tone enabled *
5
OFF
Page alert tone disabled
To page all zones, enter a Touch Tone “
0
”. The
ZPI-4
will activate all zones to which it is connected.
Otherwise, enter two Touch Tones, with the first selecting which
ZPI-4
is being addressed, and the second
selecting which zones connected to that
ZPI-4
are to be
paged. If a Touch Tone “
1
” is entered as the first digit,
the Primary is selected. If a Touch Tone “
2
” is entered
as the first digit, the Secondary is selected.
