16
Huskystar 207, 215
1.45 ~ 1.95mm (B)
(C)
(A)
NEEDLE TIMING TO SHUTTLE
The height of the needle from its lowest point (A) of travel should be in the range of 1.45 and 1.95
mm (B) when the tip of the shuttle hook just meets the left side of the needle at the left needle
position.
Adjustment.
1. Set the stitch selector dial at straight stitching ( needle in left position)
For Model 215, set it at dial at straight stitching ( needle in left position) and zigzag width at “0”.
2. Remove the base plate.
3. Open the bed cover plate.
4. Remove the shuttle race ring.
5. Turn the hand wheel towards you until the tip of the shuttle hook meets the left side of the
needle.
6. Loosen the 2 hexagon socket screws (C).
While holding the shuttle hook, turn the hand wheel towards you until the needle comes to its
lowest position. Then, continue to turn the hand wheel to raise the needle about 1.7 mm from its
lowest position.
8. Tighten the 2 screws (C).
9. Turn the hand wheel toward you to check if the height is in the range of 1.45 and 1.95 mm.
10. Attach the shuttle race ring.
11. Attach the base plate.