Viking HB 445 R, Инструкция по эксплуатации

Страница: 40 / 472

0478 403 9801 C - EN
38
2 Lifting or carrying the tiller:
● Check that the upper handlebar is
seated securely.
● Lift and carry the tiller with at least two
persons and always maintain a
sufficient distance from the hoes.
Lifting points:
Handles (1) and carrying handle (2)
3 Transporting the tiller on a load
floor:
● Always transport the tiller in the upright
position – on the transport chassis and
hoes. Never place the machine on its
side.
● To ensure stability, fold out the
transport chassis (
Ö 11.4) and mount
the hoes ( Ö 7.7), ( Ö 7.8).
● Secure the tiller on the load floor using
ropes or straps to prevent it from
slipping.
Lashing points:
Transport chassis axle (3) and hoe
axle (4).
The machine, its packaging and
accessories are all produced
from recyclable materials and
must be disposed of
accordingly.
By disposing of materials separately and in
an environmentally-friendly manner,
valuable resources can be re-used. For
this reason, the machine should be
disposed of for recycling at the end of its
useful life.
1 4. 1 Disposal
Waste products such as used oil (engine
oil, gearbox oil) and fuel must always be
disposed of properly.
Render the engine unusable prior to
disposal. In particular, remove the ignition
lead, empty the fuel tank and drain the
engine oil.
Risk of injury from the hoes!
Always store an old tiller in a safe place
prior to scrapping. Make sure that the
machine and the hoes are kept out of the
reach of children.
Important information on maintenance
and care of the product group
Petrol tillers (HB)
VIKING assumes no liability for material or
personal damage caused by the non-
observance of information contained in the
operating instructions, in particular with
regard to safety, operation and
maintenance, or which arise through the
use of unauthorised attachment or spare
parts.
Please always observe the following
important information for the prevention of
damage or excessive wear to your VIKING
machine:
1 . Wearing parts
Some parts of the VIKING machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
– V-belt
– Hoe
– Brake spur
2. Compliance with the information in
this instruction manual
The VIKING machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– Product modifications not approved by
VIKING.
– Use of fuel and lubricants not approved
by VIKING (lubricants, petrol and
engine oil, see engine manufacturer's
specifications).
– The use of tools or accessories which
are not approved or suitable for the
machine, or are of inferior quality.
– Improper use of the product.
Risk of injury!
Due to the heavy weight of the
machine, particular care must be
taken at steps, kerbs, sloping
ramps and other raised areas.
The user must always stand higher
than the machine, in order to avoid
being run over by the machine in
the case of loss of control – i.e.
push the machine down or pull the
machine up steps and slopes.
Do not push or pull the machine
over more than two or three steps.
Where there are more steps, carry
the tiller with the help of a second
person.
1 4. Environmental protection
1 5. Minimising wear and
preventing damage