VIKING GARDEN iMow MI 632 M, Инструкция по эксплуатации

Страница: 106 / 446

0478 131 9937 B - EN
104
Regularly inspect the area on which the
machine is to be used and remove any
sticks, stones, wires, bones and all other
foreign objects that could be thrown up by
the machine.
After installing the perimeter wire,
particularly remove all tools from the
mowing area. Broken or damaged fixing
pins must be removed from the lawn and
disposed of.
Regularly check the area to be mown for
uneven areas and level them out.
Never use the machine with damaged
safety devices or with safety devices
removed.
The switch and safety devices installed in
the machine must not be removed or
bypassed.
All worn or damaged parts must be
replaced before use of the machine.
Replace any illegible or damaged danger
signs and warnings on the machine. Your
VIKING specialist has a supply of
replacement stickers and all the other
spare parts.
Before initial operation, it must be ensured
– that the machine is in a safe operating
condition. This means that the covers
and guards must be in place and in
good condition.
– that the docking station is in a safe
operating condition. All covers must be
properly installed and be in good
condition.
– that the power supply unit has been
connected to a properly installed
socket.
– that the insulation of the electric cable
and the mains plug on the power supply
unit is in good condition.
– that the entire machine (housing, hood,
fastening elements, mowing blade,
blade shaft, etc.) is neither worn nor
damaged.
– that the mowing blade and the blade
fastening are in a proper condition
(secure seating, damage, wear).
(
Ö 16.3)
– that all screws, nuts and other fastening
elements are in place and are properly
tightened. Tighten any loose bolts and
nuts prior to initial operation (observe
tightening torques).
Perform all necessary work or consult a
specialist dealer. VIKING recommends
VIKING specialist dealers.
6.7 Programming
Observe local regulations regarding
permitted operating times for gardening
power tools with motors and programme
the active times accordingly. (
Ö 14.3)
In particular, programming must also be
adapted so that no children, spectators or
animals are in the area to be mown during
operation.
Changing the programming using the
iMow app can result in activities that will
not be expected by other people. Changes
to the mowing plan must therefore be
communicated in advance to all affected
people.
The robotic mower must not operate at the
same time as a sprinkler system. Adapt
the programming accordingly.
Ensure that the correct date and the
correct time are set on the robotic mower.
Correct the settings if necessary. Incorrect
values may cause the robotic mower to
start up unintentionally.
6.8 During operation
Keep other persons, especially
children
and animals, out of the
danger area.
Never allow children to approach or play
with the robotic mower during operation.
Starting a mowing operation using the
iMow app may not be expected by third
parties. Affected people must therefore be
notified in advance about possible activity
of the robotic mower.
Never allow the robotic mower to operate
unattended if you know that animals or
persons, particularly children, are in the
vicinity.
Caution – risk of injury!
Never put hands or feet on or
underneath rotating parts.
Never touch the rotating blade.
Before thunderstorms, or if there is a
danger of lightning strikes, disconnect the
power supply unit from the mains. The
robotic mower must not be operated.
The robotic mower must never be tilted or
lifted when a motor is running.
Never attempt to change settings on the
machine when one of the motors is
running.
For safety reasons, the machine must not
be used on slopes with an inclination of
more than 24° (45 %).
Risk of injury!