98
3
-
7.2 Port Group
Allow
Parameter
Description
The section describes how to allow the IP Multicast Group to receive the multicast
stream. Entries in the MVR port group allow table is shown on this page. The MVR
Port Group Table is sorted first by port and then by IP address.
Web Interface
To display the MVR Groups Information in the web interface:
1.
Click Configuration, MVR, Port Groups Allow.
2.
If you want to add the new allowed group, you need to click the “Add New
Allow Group” button.
3.
Evoke the “Port No.”, “Start Address” and “End Address”.
4.
To click the “Apply” to apply the configuration of MVR Port Group Allow
Table.
Figure 3-7.2: The MVR Groups Information
Delete:
Check to delete the entry. It will be deleted during the next apply.
Port:
The logical port for the settings.
Allow Groups:
The IP Multicast Group that will be allowed.
Adding New Allow Group:
Click “Add New Allow Group” to add a new entry to the
Group Allow table. Specifies the Port and Allow Group of the new entry. Click
"Apply".
Buttons:
Apply
– Click “Apply” to save changes.
Reset
-
Click “Reset” to undo any changes made locally and revert to
previously saved values.
