Document: LT0439 Vigilant
MX1-Au
Operator Manual
Issue 1.73
23 October 2018
Page 6-15
The Auto-Reset test will automatically cancel if no new alarm
is received for two hours. In this case, the zone will revert to
the state it was in (enabled or disabled) when the test was
started.
On exiting the test (whether stopped, reset, or timeout) if an
alarm is still present (e.g., call point left operated) the alarm
will be treated normally and may generate a nuisance alarm.
Therefore it is recommended the zone be disabled before the
test, and enabled again only after confirming 1-2 minutes
after the test is exited that the state of the zone is normal.
This test generates a fault condition for the zone. You will be asked to
confirm or cancel the test. The following display will be shown during the
test;
Zone 001 Std Detection G1 |
Office | ENABLE
| RESET
Fault Disabled FltTest |
Fig 6-24 – Fault Test Status Menu
If the zone does not go into fault, the test fails.
Note that the test will disable the zone being tested, and the fault is
simulated. If it is required to test how the system is affected by the zone
fault, the zone can be manually enabled during the test by pressing
ENABLE
F2
.
To stop the test, press
RESET
F3.
This will also restore the zone’s
enable/disable status to what it was before the test was started.
From the recall point status display, press
MENU
or
MENU
F4
to display
the menu options.
Press
TEST
F3
to display the test options for the point, which will
depend on the point type, as described in the following sections.
Alternatively, from the base display, press the
TESTS
key,
INITIATE
F4
and select
POINT
F2
. Enter the required point
number, then press
OK
.
Fault Test
Testing Points
Содержание MX1-Au
Страница 104: ...Vigilant MX1 Au Operator Manual Document LT0439 Page 23 October 2018 Issue 1 73 8 18 THIS PAGE INTENTIONALLY LEFT BLANK...
Страница 118: ...Vigilant MX1 Au Operator Manual Document LT0439 Page 23 October 2018 Issue 1 73 9 14 THIS PAGE INTENTIONALLY LEFT BLANK...
Страница 160: ...Vigilant MX1 Au Operator Manual Document LT0439 Page 23 October 2018 Issue 1 73 11 34 THIS PAGE INTENTIONALLY LEFT BLANK...
Страница 182: ...Vigilant MX1 Au Operator Manual Document LT0439 Page 23 October 2018 Issue 1 73 12 22 THIS PAGE INTENTIONALLY LEFT BLANK...