50
Using the projector in standby mode
Some of the projector functions are available in standby mode (plugged in but not
turned on). To use these functions, be sure you have turned on the corresponding
menus under
SOURCE
>
Standby Settings
, and the cable connections are correctly
made. For the connection methods, see the
Active VGA out
Selecting
On
outputs a VGA signal when the
COMPUTER IN 1
and
COMPUTER
OUT
sockets are correctly connected to devices. The projector outputs the signal
received only from
COMPUTER IN 1
.
Active Audio out
Selecting
On
outputs an audio signal when the
AUDIO IN 1
socket is correctly
connected to a proper device.
LAN Control
Selecting
On
allows the projector to provide the network function when it is in standby
"Controlling the projector through a LAN environment" on page 44
details.
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker.
Be sure you have made a correct connection to the projector audio input/output jacks.
See
for more details.
Adjusting the audio mode
1. Open the OSD menu and go to the
SYSTEM SETTING: ADVANCED
>
Audio
Settings
>
Audio Mode
menu.
2. Press
/
to select a preferred audio mode.
• If available, you can press Audio Mode on the remote control to select a preferred audio
mode.
Muting the sound
1. Open the OSD menu and go to the
SYSTEM SETTING: ADVANCED
>
Audio
Settings
>
Mute
menu.
2. Press
/
to select
On
.
• If available, you can press
on the remote control to toggle the projector audio between on
and off.
Adjusting the sound level
1. Open the OSD menu and go to the
SYSTEM SETTING: ADVANCED
>
Audio
Settings
>
Audio Volume
menu.
