Viessmann VITOWELL EASY D1, Руководство по эксплуатации

Страница: 6 / 20

This Instant Water Heater is a
single point system and the
“Water Outlet” can only
be fitted to the PVC Hose and
Handshower set provided. NO
CONTROL VALVE OR
FITTING CAN BE FITTED TO
THE WATER OUTLET.
Connect the Stop Valve to the
Water Inlet with washer. Use
correct tools to tighten the
connection and be careful not to
over tighten and damage the
plastic nut.
Connect the incoming water
piping to the Stop Valve (1/2”
BSP). Make sure to put the Mesh
Filter between Stop Valve and
incoming water piping.
If in any case, the Stop Valve
is not used or omitted, make
sure to put the Mesh Filter
between the heater unit inlet pipe
and incoming water pipe.
Turn on the water mains to
drain out all plumbing dirts, at the
same time fill up the heater tank.
THE HEATER TANK MUST BE
FILLED UP WITH WATER
BEFORE TURNING ON THE
ELECTRICITY SUPPLY TO
PREVENT ANY DRY BURNT
DAMAGE TO THE HEATING
ELEMENT.
Connect the PVC Hose and
Handshower to the outlet of the
Instant Water Heater, be sure to
put in the Washer.
Hook the Handshower to the
Sliding Rail Shower Holder and
adjust to your ideal position.
Check if any water leakage.
Do not use white tape during
piping installation.
THE WATER INLET AND
OUTLET MUST BE INSTALLED
CORRECTLY , OTHERWISE IT
MAY CAUSE A DAMAGE TO
THE HEATING ELEMENT.
DO NOT APPLY PLUMBING
CEMENT ON CONNECTION.
WHENEVER NECESSARY, USE
ONLY THREAD OR SEALING
TAPE.
Plumbing Procedure