Viessmann Vitovalor PT2, Руководство по эксплуатации

Страница: 30 / 56

30
Factory setting: 50 °C
Tap the following on-screen buttons:
1. In the default display for "DHW"
2. / for the required value
3. to confirm
Operating program
Further information can be found in chapter
"Terminology" in the appendix.
Switching DHW heating ON or OFF
Tap the following on-screen buttons:
1. In the default display for "DHW"
2. Highlighted button or .
3.
■
"ON" , if you want to switch ON DHW heating.
■
"OFF" , if you want to switch OFF DHW heat-
ing.
For information on the operating programs, see
page 16
Time program
Further information can be found in chapter
"Terminology" in the appendix.
Setting a time program
Factory setting: 05:30 to 22:00 h
You can change the time program
individually in
accordance with your requirements.
1. for "DHW"
2. for "Time program, DHW"
3. Select day of the week.
4.
5. Depending on the required change, tap the follow-
ing buttons:
to change the time phase
for a new time phase
to delete a time phase
to select the time phase if more than one
time phase is set.
6. To continue, see page 17.
Note
■
The DHW is not heated between the time phases.
Frost protection for the DHW cylinder is active.
■
When adjusting the setting, bear in mind that your
micro CHP system requires some time to heat the
DHW cylinder to the required temperature.
■
Any started water heating process continues until the
set DHW temperature is achieved, even if the stop
time has been reached.
DHW heating once, outside the time program
1. In the DHW default setting, Energy cockpit or
Favourites, tap the button (see page 20). 2. to confirm
DHW heating
DHW temperature
5835784