Viessmann VITOCROSSAL CI, Руководство по эксплуатации

Страница: 24 / 48

24
Factory setting: 50 °C
Extended menu
1.
2.
"DHW"
3. "Set DHW temperature"
4. Set the required value.
Heating program
Further information can be found in chapter
"Terminology" in the appendix.
Setting the operating program for DHW heating
For the preferred heating circuit For all heating circuits
Standard menu
1. / for the operating program:
"Heating and DHW"
or
"Only DHW"
2. OK
Extended menu
1.
2.
"Heating"
3. / for the required heating circuit if necessary
4.
"Heating program"
5. "Heating and DHW"
or
"Only DHW"
For information on the operating programs, see
page 14
Time program
Further information can be found in chapter
"Terminology" in the appendix.
Setting the time program for DHW heating
Factory setting: "Automatic"
During operation with standard room temperature (see
page 19), the DHW in the DHW cylinder will be heated
to the set DHW temperature. The time phase for DHW
heating automatically starts half an hour earlier than
the time phase for central heating with standard room
temperature. This means hot water is already available
when your system starts operating at standard room
temperature.
Extended menu:
1.
2.
"DHW"
3. "DHW time prog"
4. Set the required time phases.
To see how to set a time program, see page 14.
Note
■ The DHW is not heated between the time phases.
Frost protection for the DHW cylinder is active.
■ When adjusting the setting, bear in mind that your
heating system requires some time to heat the DHW
cylinder to the required temperature.
DHW heating
DHW temperature
5814953