48
■
Heating water buffer cylinder:
–
Select buffer temperature sensor (set the number
of buffer temperature sensors)
–
Select buffer type (select the type of heating water
buffer cylinder)
–
Set heating water buffer cylinder minimum temper-
ature (top)
–
Set buffer charging until buffer temperature sensor
–
Set buffer charging until buffer temperature
■
Additional boiler:
–
Select additional boiler
–
Set buffer charging until buffer temperature sensor
–
Set buffer charging until buffer temperature
–
Select parallel mode
■
Select connection for heating circuits 1 to 4
■
Select DHW connection
■
Select DHW circulation on boiler
■
Select solar connection:
For solar and DHW "On the boiler":
–
Select solar diverter valve
–
Set solar DHW maximum temperature
–
Set solar collector maximum temperature
–
Select set DHW temperature reheating suppres-
sion
–
Nominal flow rate collector circuit
■
Select minimum system temperature:
–
Set minimum system temperature
■
Change heating circuit designations
■
Check diagnosis (sensors)
■
Check outputs (actuators)
■
Calibrate O
2
probe (Lambda probe)
■
Fill vacuum module (optional)
■
Terminate the commissioning sequence (commis-
sioning completed)
Setting the language
Shortly after switching the power on, the display shows
"Select language"
.
Press the following buttons:
1.
|
/
~
for the required language.
2.
d
to confirm.
Enter iD number (optional)
Press the following buttons:
1.
|
/
~
for the required ID number.
The ID number is designated on the
type
plate
as follows:
"Identnummer / Numéro d`identification /
ID number"
The type plate is located on the right or left-
hand side of the boiler.
2.
d
to confirm.
Note
The iD number is displayed only for boilers with an
adjustable boiler output.
Boiler type (optional)
The current boiler type and its output rating are shown.
Press the following buttons:
1.
d
to confirm.
Note
The boiler type is displayed only for boilers with an
adjustable boiler output.
If the output rating shown does not match the type
plate, check and re-enter the ID number.
Selecting the fuel
Press the following buttons:
1.
|
/
~
for the required fuel type.
2.
d
to confirm.
Commissioning, inspection, maintenance
Commissioning the heating system
(cont.)
5679249
