Viessmann 7513244, Инструкция по установке и обслуживанию

Страница: 81 / 152

81
Coding in the delivered condition Possible change
31:... Set speed of the internal circula-
tion pump when operated as boiler
circuit pump in %, specified by the
boiler coding card 31:0
to
31:100 Set speed adjustable from 0 to
100 %
38:0 Status of burner control unit: Op-
erational (no fault) 38:≠0 Status of burner control unit: Fault
"DHW"
Select group "DHW" (see page 75).
Coding
Coding in the delivered condition Possible change
56:0 Set DHW temperature adjustable
from 10 to 60 °C 56:1 Set DHW temperature adjustable
from 10 to above 60 °C
Note
Max. value subject to boiler coding
card.
Observe the maximum permissible
DHW temperature.
57:0 Do not adjust
58:0 Without auxiliary function for DHW
heating 58:10
to
58:60 Input of a 2nd set DHW tempera-
ture, adjustable from 10 to 60 °C
(observe coding addresses "56" and
"63" in this group)
5E:0 Do not adjust
5F:0 Do not adjust
65:... Do not adjust (Information on the
type of diverter valve, specified by
the boiler coding card)
67:40 For solar DHW heating: Set DHW
temperature 40 °C. Above the se-
lected set temperature, DHW re-
heating suppression is active
(DHW heating by the boiler only if
solar energy is insufficient). 67:0
to
67:95 Set DHW temperature adjustable
from 0 to 95 °C (limited by boiler-
specific parameters)
Observe setting for coding address
"56".
6C:100 Set speed of internal circulation
pump for DHW heating 100 % 6C:0
to
6C:100 Set speed adjustable from 0 to
100 %
6F:... Max. heating output for DHW heat-
ing in %, specified by boiler coding
card 6F:0
to
6F:100 Max. heating output for DHW heat-
ing adjustable from min. heating out-
put to 100 %
71:0 DHW circulation pump: "ON" ac-
cording to time program 71:1 "OFF" during DHW heating to set
value 1
71:2 "ON" during DHW heating to set val-
ue 1
72:0 DHW circulation pump: "ON" ac-
cording to time program 72:1 "OFF" during DHW heating to set
value 2
Code 2
"Boiler"
(cont.)
5773 238 GB
Codes