Viessmann 7513244, Инструкция по установке и обслуживанию

Страница: 36 / 152

36
Commissioning steps
Inspection steps
Maintenance steps Page
• •
1. Removing the front panels ................................................................................................ 38
•
2. Checking the power supply
•
3. Filling the heating system ................................................................................................. 38
•
4. Filling the cylinder on the DHW side ................................................................................ 39
•
5. Switching on the power supply and the ON/OFF switch
•
6. Changing the language ...................................................................................................... 39
•
7. Setting the time and date ................................................................................................... 40
•
8. Note on automatic testing of the flue gas temperature sensor ..................................... 40
•
9. Venting the boiler ............................................................................................................... 41
•
10. Venting the heating system ............................................................................................... 41
•
11. Filling the siphon with water ............................................................................................. 42
•
12. Filling the solar circuit ....................................................................................................... 43
• • •
13. Checking all connections on the heating water side and DHW side for leaks
•
14. Naming the heating circuits .............................................................................................. 43
• •
15. Checking the gas type ....................................................................................................... 43
•
16. Gas type conversion (only for operation with LPG) ....................................................... 44
• • •
17. Checking the static pressure and supply pressure ........................................................ 44
• • •
18. Function sequence and possible faults ........................................................................... 46
•
19. Setting the max. heating output ........................................................................................ 47
• •
20. Tightness test on balanced flue system (annular gap check) ....................................... 47
•
21. Removing the burner ......................................................................................................... 48
• •
22. Checking the burner gasket and burner gauze assembly .............................................. 49
•
23. Checking and adjusting the ignition and ionisation electrodes .................................... 50
•
24. Cleaning the heating surfaces .......................................................................................... 50
• •
25. Checking the condensate drain and cleaning the siphon .............................................. 51
• •
26. Installing the burner ........................................................................................................... 52
•
27. Checking the neutralising system (if installed)
•
28. Checking the anode connection ....................................................................................... 53
•
29. Testing the anode earth current with an anode tester .................................................... 53
•
30. Draining the boiler on the DHW side ................................................................................ 54
•
31. Cleaning the loading cylinder ........................................................................................... 55
•
32. Checking and replacing the magnesium anode (if required) ......................................... 55
•
33. Re-assembling and filling the loading cylinder ............................................................... 56
• •
34. Checking the diaphragm expansion vessel and system pressure ................................ 56
•
35. Checking the pre-charge pressure and the DHW expansion vessel (if installed) ........ 57
• • •
36. Checking the function of the safety valves
• • •
37. Checking the firm seating of electrical connections
• • •
38. Checking all gas equipment for tightness at operating pressure ................................. 58
• •
39. Checking the combustion quality ..................................................................................... 58
Commissioning, inspection, maintenance
Steps - commissioning, inspection and maintenance
5773 238 GB