Videotec NXPTZ, Инструкция по эксплуатации

Страница: 45 / 414

Instruc
tion manual - English - EN
43 MNVCNXPTZT_1710_EN
9.1.6.9 Advanced Menu
1. Static Control: Enables control of the position
only when the pan & tilt is stopped
2.
Dynamic Control:
Enables control of the
position only when the pan & tilt is moving
3.
Cyclic Homing:
If other than zero, it sets a new
homing procedure after the specified number of
hours.
4. Economy Mode: Reduces the motor toque
when the pan & tilt is not moving. Do not enable
in presence of strong wind or vibrations.
ADVANCED
------------------------
1>STATIC CONTROL : Y
2 DYNAMIC CONTROL : Y
3 CYCLIC HOMING : 0
4 ECO MODE : Y
Fig. 70
9.1.7 Display Menu
1.
PTZ Positions:
If not on OFF, it is used to
select how the Pan, Tilt and Zoom positions
are displayed on the screen. It is possible to
select timed (1s, 3s and 5s) or constant (CONST)
display.
2.
Preset Name:
If not on OFF, it is used to select
how the text associated with the last-reached
Preset position is displayed on the screen. It
is possible to select timed (1s, 3s and 5s) or
constant (CONST) display.
3. Areas Name: If not on OFF, it is used to select
how the texts associated with active areas are
displayed. It is possible to select timed (1s, 3s
and 5s) or constant (CONST) display.
4. Pan & Tilt ID: If not on OFF, it shows the ID of
the product.
5. Received Commands: If not on OFF, it is used
to select how the received serial commands are
displayed. It is possible to select timed (1s, 3s
and 5s) or constant (CONST) display.
6.
Horizontal Delta:
This moves the menu texts
horizontally, for better centring.
7.
Vertical Delta:
This moves the menu texts
vertically for better.
DISPLAY
------------------------
1>PTZ POSITIONS : 1 S
2 PRESET NAME : 3 S
3 AREAS NAME : OFF
4 UNIT ID :CONST
5 RECEIVED COMMAND:CONST
6 HORIZONTAL DELTA: 3
7 VERTICAL DELTA : 3
Fig. 71