EN - English - I
nstruc
tion manual
2
MNVKNVXTUB_2222_EN
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.
5.1 Safety precautions before use
Before starting any operation, make sure
the power supply is disconnected.
5.2 Unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
5.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
5.4 Contents
Check the contents to make sure they correspond
with the list of materials as below:
6 Installation
If previously installed, remove the sunshield and
washer nozzle from the camera.
Align the dust prevention sunshield with the screw
holes on the front of the housing as illustrated in the
figure.
Fig.
1
Fasten the dust prevention sunshield (01) to the
front of the housing using the 3 washers and screws
supplied (02).
Fig.
2
Pay attention to the fixing. Tightening
torque: 4.5Nm.