Doc # APN-24M8.29IP
Issue Date: 03/23/2020
Revision: C
Page 51 of 71
23.2.
Add Rule
Event Add Rule page: provides how to configure the event action if there is event triggering such as
Alarm-In, Manual trigger, Motion, etc.
Name: Enter the user favorite event name (1 to 31 alphanumeric characters).
Event Trigger: Shows the Event source type to be configured.
Type: Select the Event source type. If you want to add the event trigger condition for the event action,
click the AND checkbox and then select one of the event trigger types.
Event Action: Provides that the camera will perform certain actions.
Alarm out: Click the Active output port checkbox to enable the Alarm out port.
Video Boost: Click the Active output port checkbox to enable the Video Boost stream.
Image (AE): Click the Active output port checkbox to enable the Shutter and Gain state change.
E-mail: Click the Email checkbox to enable the emailing below each email address.
•
To email address: Click each email addresses checkbox.
NOTE
If you want to add additional messages when emailing, click in the Subject / Additional Info box and type
a description for the text you are creating (0 to 255 alphanumeric characters).
Notification Server: Enter the message to inform the server.
FTP: Click the FTP checkbox to enable the image uploading to the FTP server using JPEG image.
Record: Click the Record checkbox to enable the image recording to the SD Card.
23.3.
ONVIF Mapping
An ONVIF mapping is a set of parameters describing the ONVIF standard and how the camera will perform
given certain actions.
•
Event Topic: Describe the event topic on this camera.
CONFIDENTIAL
