Victron energy Phoenix Inverter 24/3000, Руководство пользователя

Страница: 18 / 144

16
Setting ds2 and ds1 for parallel operation
Master Slave 1 Slave 2 (optional)
DS-8 not used off
DS-7 not used off
DS-6 not used off
DS-5 AES na x
DS-4 Inv. voltage Set
DS-3 Inv. freq Set
DS-2 Master off
DS-1 Master on
DS-8 not used off
DS-7 not used off
DS-6 not used off
DS-5 na x
DS-4 na x
DS-3 na x
DS-2 Slave 1 off
DS-1 Slave 1 off
DS-8 not used off
DS-7 not used off
DS-6 not used off
DS-5 na x
DS-4 na x
DS-3 na x
DS-2 Slave 2 off
DS-1 Slave 2 on
To store the settings after the required values have been set: press the 'Up' button of
the
master for 2 seconds ( upper button to the right of the DIP switches, see appendix
A, position J). The overload and low-battery LEDs will flash to indicate
acceptance of the settings.
You can leave the DIP switches in the selected positions, so that the settings can
always be recovered.
Setting ds2 and ds1 for 3-phase operation
Leader (L1) Follower (L2) Follower (L3)
DS-8 not used off
DS-7 not used off
DS-6 not used off
DS-5 AES na x
DS-4 Inv. voltage Set
DS-3 Inv. freq Set
DS-2 Leader on
DS-1 Leader off
DS-8 not used off
DS-7 not used off
DS-6 not used off
DS-5 na x
DS-4 Set
DS-3 na x
DS-2 L2 off
DS-1 L2 off
DS-8 not used off
DS-7 not used off
DS-6 not used off
DS-5 na x
DS-4 Set
DS-3 na x
DS-2 L3 off
DS-1 L3 on
As the table above shows, the Inverter voltage should be set separately (ds4) for
every Inverter
AES can be used on stand alone units only.
To store the settings after the required values have been set: press the 'Up' button of
the
Leader for 2 seconds ( upper button to the right of the DIP switches, see appendix
A, position J). The overload and low-battery LEDs will flash to indicate
acceptance of the settings.
You can leave the DIP switches in the selected positions, so that the settings can
always be recovered.
To start the system: first, turn all devices off. The system will start up as soon
as all devices have been turned on.