Victron energy Lynx Smart BMS 500, Руководство пользователя

Страница: 34 / 40

11. Appendix
11.1. LED indications, warnings, alarm and error codes
LEDs
The Lynx Smart BMS is equipped with two LEDs, the Bluetooth LED and the Status LED. These LEDs will indicate the operation
mode and the fault mode in case there is a fault.
Bluetooth LED Description
Off
No system power or Bluetooth disabled in VictronConnect app. Bluetooth
can be disabled in both, VictronConnect and a GX device, but only
enabled from a GX device.
Blue on A Bluetooth device is connected to the Lynx Smart BMS
Blue flashing Bluetooth is active but no device is connected
Blue flashing at 3 seconds interval
The Lynx Smart BMS is in OFF mode but is still accessible over
Bluetooth
Status LED Description
Off The Lynx Smart BMS is in OFF mode
Orange on Initializing or shutdown
Orange blinking Delayed shutdown due to cooling down the pre-charge circuit
Green on Running, the contactor is closed
Green blinking Pre-charging
Green flashing at 3 seconds interval The Lynx Smart BMS is in Standby mode
Green and red alternating System in bootloader mode (updating firmware)
Red flashing 1 time every 4 seconds Warning, see VictronConnect for more information
Red flashing 2 times every 4 seconds Battery communication error, check battery BMS cables
Red flashing 3 times every 4 seconds High/low cell voltage or high/low temperature detected
Red flashing 4 times every 4 seconds High BMS temperature detected
Red flashing 5 times every 4 seconds Pre-charge time out
Red flashing 6 times every 4 seconds Pre-charge high current
Red flashing 7 times every 4 seconds Probably wrong system voltage
Red flashing 8 times every 4 seconds Contactor current too high
Red flashing 9 times every 4 seconds Initialization error
Red flashing 10 times every 4 seconds Safety contactor failure
Red flashing 12 times every 4 seconds Internal supply error
Red flashing 14 times every 4 seconds Battery voltage not allowed
Warning, alarm and error codes
Warning, alarm and error codes are also reported via the VictronConnect app or a connected GX device and VRM.
A warning indicates a problem that, if not corrected, will result in a system shutdown, while an alarm indicates the reason for the
system shutdown.
Lynx Smart BMS
Page 31 Appendix