Vicon V8360W Series, Руководство пользователя

Страница: 16 / 94

16
2.4 Network Connection & IP assignment
The network camera is designed for use on an Ethernet network and requires an IP address
for access. Most networks today have a DHCP server that automatically assigns IP addresses
to connected devices. By the factory default, your camera is set to obtain the IP address
automatically via DHCP server. If your network does not have a DHCP server the network
camera will use 192.168.1.100 as the default IP address.
If DHCP is enabled and the product cannot be accessed, run the “Smart Manager” utility to
search and allocate an IP address to your products, or reset the product to the factory default
settings and then perform the installation again. The utility can be found on the Vicon website
www.vicon-security.com , on the Software Downloads page for Vicon cameras.
1)
Connect the network camera/device to the network and power up.
2)
Start SmartManager utility (Start > All programs > SmartManager > SmartManager). The main
window will display, and after a short while any network devices connected to the network will be
displayed in the list.
3)
Select the camera on the list and click right button of the mouse. The pop-up menu displays as
below.
4)
Select Assign IP Address. The Assign IP window will display. Enter the required IP address.
.
NOTE: For more information, refer
to the SmartManager User Manual.