Vicon SURVEYOR 2000 7003-00, Руководство по установке и эксплуатации

Страница: 50 / 64

Verifying Proper Operation
Set up a remote keypad via RS-422/485 or a NOVA/VPS CPU via RS-422/485 or Vicoax protocol to the
Surveyor2000. Power-on the control device and verify that it boots up. Set up the control device for operation
with the Surveyor2000 in accordance with its Installation and Operation Manual.
For a Vicon model V1300X-RVC or V1300X-DVC keypad connected directly to the Surveyor2000 or through
a CPU, use the following procedure to access Surveyor2000 programming:
Figure 35
Main Menu
1. Slide the keypad’s PGM-RUN switch to the
PGM position.
2. Press the PP ENTER key; the PRESET
LED displays a blinking 0.
3. Press the 9 and 4 numeric keys in that
order.
4. Press the PP ENTER key again. The
PRESET LED display remains with the
number 94 and the monitor displays the
Surveyor2000 Main Menu, as shown in
Figure 35.
5. Set up the Surveyor2000 as desired using
the remote keypad. Proper operation has
been verified.
Use of the Auto-Baud
Detect Feature
Entering Preset 95 will start the Auto-Baud
Detect feature. It allows the camera dome to
detect a new baud rate from the host controller
without having to cycle AC power. This feature
is especially useful when the camera dome will
be set up remotely at one baud rate and
installed into a system having a different baud
rate. See Figure 36. (Note: Figure 36 is only a
sample screen.)
Figure 36
Auto-Baud Detect Screen
After configuration of Surveyor2000 is
complete, set the baud rate for the new host
system before powering down and
disconnecting as follows:
1. Slide the keypad’s PGM-RUN switch to the
PGM position.
2. Press the PP ENTER key; the PRESET
LED displays a blinking 0.
3. Press the 9 and 5 numeric keys in that
order.
46
•
Operation XX031-01 Rev 803 Surveyor2000 Camera Dome System