Part No. 8009-8028-10-00 Rev 102
Instruction Manual XX028-10
••
1
Instruction Manual XX028-10
Introduction
The information in this manual covers the installation of the SUR4-PH Pendant Housing for the Surveyor4 Fixed-
Position Camera Domes. This unit should be installed by a qualified technician using approved materials in
accordance with national, state and local codes. Read these instructions through completely before attempting
installation.
The SUR4-PH provides pendant mounting for the Surveyor4 Fixed-Position Camera Domes. Refer to Installation and
Operation Manual XX028 for Surveyor4 Camera Domes for complete installation instructions. It is used in conjunction
with an S2000-UWM wall mount. Refer to Installation and Operation Manual XX036 for installing the wall mount.
Installation
If it is desired that the Surveyor4 Dome Camera be installed in a pendant configuration, it must be installed in a
SUR4-PH pendant housing. The accessory kit for the housing includes necessary hardware for installation. The wall
material must provide suitable strength to support the weight of the Surveyor4 and the SUR4-PH combined, which is
approximately 5.75 lb (2.6 kg). Be sure the area in the selected location is clear of obstacles (such as steel beams,
headers, pipes, electrical wiring, etc.), which would interfere with mounting. Video and power cables must be routed
to the location. Follow the steps below and refer to Figures 1, 2, 3 and 4.
1. Install the wall mount using appropriate 3/8-inch (metric M9) hardware for the installation surface and run the
cables through it according to instruction manual XX036.
2. Run the cables to the Surveyor4 according to the installation manual.
3. Wrap the Teflon tape supplied clockwise around the threads of the wall mount to ensure a snug fit.
4. Remove the electrical box from the Surveyor4 assembly by removing the two (2) screws that secure it to the
enclosure and discard.
5. Attach the Surveyor4 enclosure to the SUR4-PH mounting plate, using the mounting holes noted in Figure 2,
with the 8-32 screws provided.
6. Screw the SUR4-PH assembly onto the wall mount. Tighten the set screw (Figure 3) next to the mounting
opening of the housing with an Allen wrench (1/16, not provided) to lock the housing to the mount.
7. Connect the cables to the connectors on the enclosure. See Figure 4. (Use an isolated power source.)
8. Continue with the instructions in the Surveyor4 installation manual for camera configuration.
Copyright © 2002 Vicon Industries Inc. All rights reserved.
Vicon and its logo are registered trademarks of Vicon Industries Inc.
Product specifications subject to change without notice.
VICON INDUSTRIES INC., 89 ARKAY DRIVE, HAUPPAUGE, NEW YORK 11788
TEL: 631-952-CCTV (2288) FAX: 631-951-CCTV (2288) TOLL FREE: 800-645-9116
24-Hour Technical Support: 800-34-VICON (800-348-4266)
UK: 44/(0) 1489-566300 INFOFAX: 800-287-1207 WEB: www.vicon-cctv.com
All manuals and user guides at all-guides.com
all-guides.com
