Vicon RV 4116, Руководство по эксплуатации и обслуживанию

Страница: 95 / 192

4
83-007-0.
fm
ID
M
English
- 89 -
▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ Pick-up unit (wide type)
Part 4
HOW TO REMOVE PRODUCT CLOGGING IN THE PICK-UP UNIT
71
Follow the instructions.
1. Make sure tractor PTO is disen-
gaged.
2. Stop the engine, apply the park-
ing brake and disengage the ig-
nition key.
3. Remove the product that clogs
the pick-up unit (A) by using the
specific tool (B) .
4. Disassemble the baffle plate , if
necessary, to make the product
removal easier.
5. Restart the motor, and then acti-
vate the power take-off to check if
the pick-up unit has unlocked.
If not so, open the tail gate and ac-
tivate the bale unloading to make
the product removal operation
easier.
HOW TO BALANCE THE PICK-UP UNIT
72
Balancing has to be performed according to the speed of the forward
movement of the machine, as well as to the conformation of the ground.
A correct balancing allows the pick-up unit to keep resting on the ground
with the wheels, and to lift correctly when it knocks against an obstacle.
Important
The pick-up unit must be balanced in such a way as to exercise a
force of approximately 300÷400 N (30÷40 kg) over the soil.
To perform balancing, follow the in-
structions.
1. Make sure tractor PTO is dis-
engaged.
2. Stop the engine, apply the
parking brake and disengage
the ignition key.
3. Open the cover (A) .
4. Adjust the compression of the
spring (D) by means of the lock
nut (B) and the tightener (C) .
- Screw the tightener (C) to re-
duce spring (D) loading.
- Loosen the tightener (C) to in-
crease spring (D) loading.
5. Tighten the lock nut (B) when
the operation is completed.
6. Close the cover (A) .
The dimension shown in
the picture is approximate.
Its value may vary accord-
ing to the position and the
work conditions of the pick-
up unit.
ID
M
-48300700
300.
pdf
B
A
450mm
C
B
A
ID
M
-2
1
7
2
0
6
0
0
6
0
1
.p
d
f
D