Specification
Specifications*
SLICK s10
SLICK s12
SLICK s15
Speaker Size
10" (274mm)
12" (323mm)
15" (392mm)
RMS Power
350w
400w
500w
Peak Power
1000w
1200w
1500w
Min input RMS
175w
200w
250w
Sensitivity
88dB
90dB
92dB
Frequency Response
30 - 1700Hz
25 - 1500Hz
20 - 850Hz
Impedance
4ohm
4ohm
4ohm
Mounting Diameter
232mm
275mm
350mm
Mounting Depth
126mm
133mm
168mm
Displacement
0.21Cu.Ft.
0.28Cu.Ft.
0.49Cu.Ft.
Recommended Amp
SLICK a0
SLICK a0
SLICK a0
SLICK a1
SLICK a1
SLICK a1
SLICK a7
SLICK a7
SLICK a7
Introduction
This instruction manual is for your safety and must be adhered to at all times. Please read, ensure that you fully understand
the installation and set up procedures as explained and if you are unclear on the installation or set up of your VIBE SLICK
speakers please contact your nearest authorised VIBE dealer.
WARNING
DO NOT EXPOSE THIS PRODUCT TO DAMP OR MOISTURE - doing so may result in fire, shock or damage to the product.
ENSURE GOOD AND CORRECT CONNECTIONS - failure to make the correct connections may result in fire or damage to the product.
KEEP THE VOLUME AT A LEVEL SO YOU CAN STILL HEAR OUTSIDE NOISE - failure to do this may result in an accident. VIBE equipment is
capable of producing sound levels that can permanently damage your hearing. VIBE recommends caution when listening at high volume. For
safe and enjoyable listening the sound should be comfortable and clear without distortion.
CAUTION
Never connect any speaker lead to the car chassis. This can cause severe damage to your speaker /car radio /amplifier.
Before drilling or cutting any holes, investigate the layout of your vehicle thoroughly.
Use caution when working near the fuel / hydraulic lines and electrical wiring.
Observe the correct polarity when wiring, improper phasing may cause a loss of bass response.
Ensure that no moving parts catch on the speaker or grill (e.g. window or door handles, or window glass inside the door)
Installation
The quality of the installation will affect the system performance and reliability.
Contact your nearest authorised VIBE dealer if you are unsure about the installation of this product.
Please mount this unit away from any potential hazards.
Minimising the length of wires will provide higher audio output from the system.
The speaker should be securely fastened to the mounting position using the screws provided.
Pre drill your mounting holes using a drill and position with the template provided.
Be sure to investigate your mounting area thoroughly for electrical wires, brake or fuel lines or fuel tank to prevent causing any damage.
Congratulations on purchasing your SLICK subwoofer, please read this manual in order to
fully understand how to get the best results from your speakers and ensure that all advice on
how to look after your speakers is followed.
Thank you for buying VIBE, we hope you enjoy listening to your product as much as we enjoyed
creating it.
VIBE R&D Division
OWNERS MANUAL
Model: SLICK s10 s12 s15
Содержание SLICK s10
Страница 8: ...NOTES ...
