Viavi Xgig1000, Руководство по оборудованию

Страница: 114 / 172

Chapter 2 Xgig1000 System Setup
Xgig1000 Chassis Startup Sequence
Page 98 Xgig1000 Hardware Guide March 2017
Xgig1000 Chassis Startup Sequence
The following is the start up sequence that you will observe when you power on the
Xgig1000 chassis.
1 Plug the chassis in to start up the Xgig1000 chassis.
2 Turn the chassis on using the power switch on the back of the chassis. If the chassis
does not have a power switch on the back, skip this step.
3 If the power on sequence is not initiated automatically, press the Front Panel Reset
button.
4 Wait several minutes.
5 When the Management Port is connected to the network, the remainder of the start
up sequence continues.
6 All of the following events occur at the same time. The Sync Discovery operation
takes the longest to complete.
a The Management Port activates.
b The blade initializes, and LEDs for the ports activate (not all LEDs for all ports
will activate).
c The Sync Discovery operation starts, and the LEDs on the Cascade port blink.
During a Sync Discovery, the cascaded chassis go through the process of
discovering how many units are cascaded together and reset ports accordingly.
Sync Discovery may take several minutes.
7 When the Xgig1000 chassis has finished booting and Sync Discovery has
completed, the Cascade ports stop blinking and turn solid green if there are
cascaded chassis. Otherwise, no LEDs are lit for the Cascade ports.
Note that when a reboot or a Sync Discovery is initiated, all existing data in the capture
buffer of any Xgig blade within the chassis is lost. Sync Discovery can also be initiated by
a command from the Xgig Web interface utility.