Chapter 3
Testing
Assessing WiFi performance throughout a site
WiFi Advisor Wireless LAN Analyzer User’s Guide
September 2015
22073751, Rev. 003
Page 39
Step 2: Specifying the Broadband Service Rate
This setting specifies the broadband service rate that the customer is receiving from their internet provider. If not specified (left
blank), the setting is ignored.
To specify the Broadband Service Rate
1
From the Site Assessment page, select
Broadband Service
.
2
Enter the rate in MBit/s.
Step 3: Specifying the configuration
The configuration page specifies the profile(s). Multiple test profiles may be configured as part of a test sequence. The sequence
is repeated at each location and always executed in the same order. A Site Assessment configuration with multiple profiles will
allow any profile to be enabled or disabled for the test session. Once defined, the profile On/Off settings will apply to all locations
tested in that session.
To specify a configuration
1
From the Site Assessment page, select
Configuration
.
2
Do one of the following:
a
Select the predefined configuration that matches your needs or matches the equipment you are installing. Proceed to
“Step 4: Specifying the AP and Station Location” on page 44
.
Individual profiles within a test configuration sequence can be enabled / disabled (use theslide button. Profile selec-
tions remain as configured for the duration of the Site Assessment test (once they are configured, they can’t be
changed from one location to the next).
