Viavi T-BERD MTS 5800, Руководство по началу работы

Страница: 164 / 296

Chapter 4 Basic Testing
VT-100 emulation
T-BERD/MTS/SC Getting Started Guide
Page 140 22046537, Rev. 016 March 2018
3 To specify the settings required for the session, select VT-100 Setup . The VT-100
Setup screen appears.
a Under Port Settings, specify values for the following:
b Under Terminal Settings, specify values for the following:
4 Select the Terminal Window softkey to return to the VT-100 Terminal screen,
then use the keyboard to issue commands just as you would on a VT-100
terminal.
You are running a VT-100 session.
Saving terminal screen data
When running a VT-100 session, you can capture the data on the terminal screen. The
instrument saves the data to an ASCII file; you can export the file just as you would any
other report on the instrument (see
“Exporting reports” on page 137 ).
Setting Value
Baud Rate Select one of the predefined baud rates ranging from 50 to
115200 Kbps.
Data Bits Select the number of data bits (ranging from 5 to 8) that
contain information. These are the bits that are not used to
start, stop, or provide checksum values.
Parity Indicate whether no parity check will be performed (None),
or whether the instrument will use odd or even bits for par-
ity checking.
Stop Bits Indicate whether bit 1 or bit 2 will be used as the stop bit.
Flow Control Indicate whether the instrument will use software ( X ON /
X OFF codes), hardware, or no flow control ( None ).
Setting Value
Enter/Return Select CR to send a carriage return every time you
press Enter, LF to send a line feed, or CR + LF to send
both.
Local Echo If you want to echo the characters you type on the
MSAM screen, select
ON ; otherwise, select OFF .
Enable Reserved
Keys If you want to use the keyboard’s function keys when
communicating with the network element, select
Enable ; otherwise, select Disable .
NOTE:
If you enable reserved keys, the buttons on your instru-
ment will be
disabled . Be certain to change this setting
back to Disable when you are done with your VT-100
session.