Viavi T-BERD MTS 5800, Руководство по началу работы

Страница: 163 / 296

Chapter 4 Basic Testing
VT-100 emulation
T-BERD/MTS/SC Getting Started Guide
March 2018 22046537, Rev. 016 Page 139
To establish a serial connection for VT-100 emulation
1 Turn the Dual Module Carrier, Transport Module, and MSAM ON.
2 Verify that you have the Viavi supplied cable that shipped with the VT-100 option
or with your test instrument.
3 Connect the USB connector to one of the USB slots on the top panel of your test
instrument.
4 Connect the DB-9 serial connector to the network element.
A connection is established.
Running a VT-100 session
After establishing a serial connection to the network element, you can run a VT-100
terminal emulation session to query or configure the element.
To run a VT-100 terminal emulation session
1 If you haven’t already done so, turn the Dual Module Carrier, Transport Module,
and MSAM ON, and establish a connection to the network element (see
“Estab-
lishing a serial connection” on page 138 ).
2 From the Menu Bar, select Tools > VT-100 Emulation .
The VT-100 Terminal screen appears, with softkeys to the right that allow you to
do the following:
–
VT-100 Setup . Use this softkey to specify values for the session (as
described in step 3 on page 140 .
– Clear Screen . Use this softkey to clear the data currently displayed on the
terminal screen.
– Hide Keyboard . Use this softkey to hide the keyboard. This is helpful when
using a USB keyboard, or if you want to observe more data on the terminal
screen.
– Move Keyboard . Use this softkey to move the keyboard to the top or bottom
of the terminal screen. This is helpful if the keyboard is blocking the display of
key data.
– Autobaud . Use this softkey to send a series of sequential space characters
to force the network element to re-evaluate its baud rate.
– Capture Screen . Use this softkey to capture the data on the terminal screen
and save it in an ASCII file.
– Exit . Use this softkey to end the session and return to the Main screen.