Viavi T-BERD 6000A V2, Руководство пользователя

Страница: 61 / 188

Chapter 6 Scope
Starting up with the scope
User Manual 76100000200 Rev. 001 41
Starting up with the scope
Once the FiberScope icon is validated:
1 Press R
ESULTS
hard key
Use the Focus Control button onto the P5000i scope (see Figure 14 on
page 36 ) to adjust the image quality and sharpness.
Freeze mode
Once the image is acceptable, you may freeze the picture. This feature
allows to store in memory the resulting picture.
Fig. 18 Example of the result using the P5000i scope
Focus level for
image sharpness
NOTE
To switch from Scope page to FO results page and vice-versa, press
the
R
ESULTS
hard key for about 2 seconds (a beep is emitted).
Freezing a scope result does not store the picture in a file (see "File
menu" page 46 ). The result will be lost if the instrument is shut off, or if
more than 3 pictures are frozen (see "Mosaic Mode" page 44 ).
NOTE
The button set on the lead, or the QuickCapture™ on the P5000
allows to freeze the picture, and to launch a test (according to config-
uration in Setup page - see
“Configuring the Scope” on page 37 ).