Viavi T-BERD 6000A V2, Руководство пользователя

Страница: 60 / 188

Chapter 6 Scope
Configuring the P5000i Scope
40 User Manual 76100000200 Rev. 001
Adding a new
profile
Once the Setup screen of the scope is displayed, you can add a specific
profile which will be used for the test.
The profile must be created via FiberChek2
TM
, and stored on one
storage media of the MTS/T-BERD 6000A V2 (disk, hard disk or USB
memory stick).
1 On the Setup screen, select Profile and press Add key.
2 On the explorer, select the file which will be used as profile (icon
; extension: .PRO)
3 Press Load .
Once loaded, the display goes back automatically to Setup screen.
4 Select the profile just loaded.
Removing a profile
1 In the Profile list, select the profile to be deleted.
2 Press Remove key., then Exit .
About page
On the Setup screen, the softkey About , on the right of the screen,
allows to display information on scope and current test result displayed
(in Full Screen mode or mosaic mode - see
“Mosaic Mode” on page 44 ).
1 Press About softkey to display a page as the following one:
Fig. 17 About page
Information on
scope
Information on
active test result