MCA III User’s Guide
22137817, Rev. 000
Feb 2020
41
Chapter
3 Appendix
Display messages and error codes
Device errors
The codes shown below are displayed on the MCA III
display as
Device Errors
or
MCA III Error
to indicate an
error with the MCA III.
##
Error description
Solution
3
Factory calibration is not valid
Return the device to the factory for
repair.
4
User parameters are not valid
Use Seeker Setup to reconfigure the
device.
7
Invalid flash ID detected
Cycle power on the unit, if the error
persists return the device to the
factory for repair.
8
Flash memory is Full
Use any of the means available to
either erase the data, synchronize to
the meter, or move the data to a valid
LAW connection.
9
Flash memory write failed
If the error persists, return the device
to the factory for repair.
10
Wi-Fi SPI interface failed
If the error persists, return the device
to the factory for repair.
11
Wi-Fi module boot failure
If the error persists, return the device
to the factory for repair.
