Chapter 3
mA-6806 Vector Signal Transceiver Setup and Installation
Module Installation Procedure
Final
mA-6806 AXIe Vector Signal Transceiver Operation Manual
Page 12
July 2019
How to Install the Module
1
Power down the Chassis.
2
Position the Module on Chassis Side Rails.
3
If Module has Securing Latches, position Securing Latches at a 90°.
4 Slide Module along the Side Rails. Verify Module is properly aligned and does not
catch on Side Rails.
5 Slide Module into Card Cage. Press firmly to securely connect Module pins with
Backplane Assembly Connectors.
6 Press Securing Latches closed and place Securing Latches in Locked Position.
7 Hand tighten Captive Screw on each side of Module.
8 Securely tighten each Captive Screw to ensure Module is properly grounded via the
Chassis.
NOTE
The securing latch must be placed in the unlocked position - pulled out and away from
the latch mechanism.
Figure 3
Securing Latch - Locked Position
Figure 4
Securing Latch - Unlocked Position
Figure 5
Securing Latch - Unlocked and unlatched
