Viavi CellAdvisor 5G, Руководство пользователя, Страница: 165 / 359

CellAdvisor 5G User's Guide
153
Setting measure setup
After configuring spectrum measurement in " Configuring Spectrum Measurements ", you can set the measure setup to continue your
measurement. The measurement settings can be saved and recalled as a file by selecting File Type as Setup and load the file onto
the instrument using the Save/Load icons on the side bar.
1 Tap the Setup ( )icon on the side bar.
2 Tap Bandwidth and select the value from the following choices: 1.4 MHz , 3 MHz , 5MHz , 10 MHz , 15 MHz, or 20 MHz .
3 Optional. Tap Physical Cell ID and select the type Manual or Auto .
Auto lets the instrument detect the Physical Cell ID for the LTE signal automatically, and Manual sets a specific Physical Cell
ID for the LTE signal manually in order to speed up the synchronization with a BTS.
4 Optional. To select the number of antenna ports, tap the MIMO and select 2x2 or 4x4 .
5 Optional. To assign an antenna port number automatically or manually, tap the Antenna Port under Antenna menu and select
the option: Auto , Antenna 0 , Antenna 1 , Antenna 2 , or Antenna 3 .
If the MIMO is set to 2x2, the antenna ports 2 and 3 are disabled.
6 To set the delay, tap Delay and enter the value using the on-screen keyboard to set the amount of delay in
μs.
NOTE:
The Delay setting is used only when there is a time offset in the signals to be measured.
7 Optional. To select the Cyclic Prefix, tap Cyclic Prefix and select Normal or Extended .
Setting limit
1 Tap Menu > Limit .
2 Tap to switch the RS EVM/ DL RS Power/ MIMO to set the Test limits to On or Off with setting High and (Low) Limits using
the on-screen keyboard to enable or disable Pass/Fail indication.
Time Alignment Error measurement with LTE/LTE-A TDD Analyzer
Data Allocation Map
The Data Allocation Map function represents data allocation as a frame.