Viavi CellAdvisor 5G, Руководство пользователя, Страница: 258 / 359

Using NSA Signal Analyzer
246
1 If required, connect a GPS receiver to your CellAdvisor 5G for outdoor mapping. Indoor mapping does not necessarily need a
GPS antenna.
2 Tap the Cancel or Apply button when Display pop-up window appears.
3 Tap the Setup ( ) icon on the side bar.
4 Tap Plot Point and select GPS or Position or Time .
a To collect data/plot points automatically as you move around in a vehicle or outside (outdoor), select GPS and then tap to
switch to the Screen Mode between Map and Full .
With the Map setting, you can view only the collected points that can be seen within the boundary of the loaded map.
With the Full setting, you can view all the collected points of the route without the loaded map.
b To collect data/plot points manually in indoor layout without a GPS antenna, select Position . (If you tap the Start button
( ) on the right panel of the map, the Undo icon appears).
5 Tap to switch Plot Item to RSRP , RSRQ , SINR or SNR .
6 Tap Configuration to continue with carrier setting or general setting.
General setting
1 Tap General Setting on the screen.
2 To set the reference level, tap the number under NR or LTE and input the reference level using the on-screen keyboard.
3 Tap to switch the Sweep Speed between Fast and Normal .
a Fast : measuring PCI, RSRP, RSRQ, P-SS SNR, S-SS SINR, S-SS RSSI, P-SS Power, S-SS Power for one signal with
the strongest RSRP for LTE carrier/ measuring PCI, SSB Index, S-SS RSRP, P-SS RSRP, P-SS SNR, S-SS SINR, S-SS
RSRQ for one signal with the strongest S-SS RSRP for NR carrier.
b Normal : measuring PCI, RSRP, RSRQ, P-SS SNR, S-SS SINR, S-SS RSSI, P-SS Power, S-SS Power for six signals
with top-down order based on the strongest RSRP signal for LTE carrier/ measuring PCI, SSB Index, S-SS RSRP, P-SS
RSRP, P-SS SNR, S-SS SINR, S-SS RSRQ for eight signals with top-down order based on the strongest S-SS RSRP
signal for NR carrier.
4 Tap Trigger to set Internal , External or GPS as required.
a Internal : when starting a signal processing using the internal reference clock and creating a trigger.
b External : when starting a signal processing based on the external input trigger
c GPS : When synchronizing the signal processing via the GPS receiver.
Carrier setting
1 Tap the number to switch the carrier on or off for NR or LTE in the Carrier Configuration box. You can select up to 8 carriers.
2 If you select NR, do the following steps:
a Tap the Center Frequency box and input the value using the on-screen keyboard.
b Tap the Channel Standard box and choose one from the pop-up window and tap the Apply button.
If the MIMO is set to 2x2, the antenna ports 2 and 3 are disabled.
c Tap the Channel Number box and input the value using the on-screen keyboard.
d Tap the External Offset box and input the value using the on-screen keyboard and tap to switch the external offset to On
(green) or Off (gray) as desired.
e Tap the Attenuation box and input the value using the on-screen keyboard if you want to set it manually ( Manual ). Or tap
it to set Auto .
f Tap to switch the Preamp box 1 , 2 , DNC , and Auto to On (green) or Off (gray.
g Tap to switch the PCI ( Physical Cell ID ) box to Manual (number) or Auto and input a value in the number box from 0 to
1007 using the on-screen keyboard.