ViaSat VMBR-1520, Инструкция по установке, эксплуатации и обслуживанию, Страница: 8 / 88

VMBR-1520 Mobile Broadband Router Installation, Operation and Maintenance Guide
1075152 Rev. 001
ii
REGULATORY COMPLIANCE and NOTICES
FCC Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class TBD) digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate rad io frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Shielded I/O cables must be used and all covers must be in place when operating this equipment.
Canadian Department of Communications compliance statement:
This equipment does not exceed Class A limits per radio noise emissions for digital apparatus set out in the Radio Interference
Regulation of the Canad ian Department of Communications. Operation in a res idential area may cause unacceptable interference to radio
and TV reception requiring the owner or operator to take whatever steps are necessary to correct the interference.
Avis de conformite aux normes du ministere des Communications du Canada:
Cet equipment ne dépasse pas les limites de Class A d’émission de bruits radioélectriques pour les appareils numériques tels que
prescrites par le Règlement sur le brouillage radioélectrique etab li par le ministére de Communications du Canada. L’exploitation faite en
milieu rés identiel peut entrainer le brouillage des réceptions radio et télé, ce qui obligerait le propriétaire ou l’operateur à prendre les
dispositions nécessaires pour en éliminer les causes.
Electro-Magnetic Emissions Compliance
The equipment has been tested for compliance with the following emissions and immunity requirements:
Emissions:
FCC 15B, Sec. 107, Class “A” Conducted Emissions
FCC 15B, Sec. 109, Class “A” Radiated Emissions
EN 55022: 2006, Class “A” Conducted Emissions
EN 55022: 2006, Class “A” Radiated Emissions
CISPR 22: 2006, Class “A” Conducted Emissions
CISPR 22: 2006, Class “A” Radiated Emissions
EMC:
EN 55024:1998, Amendment A2: 2003
Immunity characteristics — Limits and methods of
measurement, Amendment A2:2003 to EN 55024:1998
IEC 61000-4-2: 2001, EN 61000-4-2: 1995; Amendment A2, 2001 ESD Immunity
IEC 61000-4-3: 2006, EN 61000-4-3: 2006 Radio Frequency Immunity
IEC 61000-4-4: 2006, EN 61000-4-4: 2004 Electrical Fast Transient Immunity
IEC 61000-4-5: 2005, EN 61000-4-5: 2006 Surge Immunity
IEC 61000-4-6: 2006, EN 61000-4-6: 1996; Amendment 1, 2001 RF Common Mode Immunity
IEC 61000-4-8: 2006, EN 61000-4-8: 1993; Amendment A1, 2001 Power frequency magnetic field immunity
IEC 61000-4-11: 2004, EN 61000-4-11: 2004 Voltage Dips and Short Interruptions
IEC 61000-3-3: 2005, EN 61000-3-3: 1995, Class “A”
Voltage F lucuation and Flicker
IEC 61000-3-2: 2005, EN 61000-3-2: 2006, Class “A” Current Harmonics Emissions